in ,

New Samsung Galaxy S3 Android 4.1 Jelly Bean Update ODIN I9300XXDLH4 Leaked

A second Android 4.1 Jelly Bean update for Samsung Galaxy S3 has recently been leaked providing those who have the guts to flash unofficial firmware into their devices another option to enjoy the goodness of the latest version of Google’s mobile operating system. A couple of weeks ago, there was also a leakage of the alleged official copy of Jelly Bean for Galaxy S III and some developers have tested it.

Sam Mobile was the first to publish the leakage. They claim they gotten hold of the firmware but couldn’t share it with anyone as it was available as an OTA (over the air) update. The site was among the few ones that received updates much earlier in the past and as far as credibility is concerned, Sam Mobile is credible enough. Moreover, the guys who tested it said they applied the firmware to their own device and repackaged it so it could be applied to other devices irrespective whether they are carrier-dependent or not.

Dubbed as ODIN I9300XXDLH4, the firmware was a pre-release so basically, it was not official and caution should be taken when updating it on Galaxy S3. It is said to increase the binary counter and there should be some bugs. Also, it would surely void warranty. Unless you know exactly what you’re doing, don’t proceed.

How to Flash ODIN I9300XXDLH4 on GS3

These are the simplest steps to install this firmware on any version of Galaxy S III:

  1. Unzip the package.
  2. Run Odin 3.04 which is already included in the package.
  3. Reboot Galaxy S3 to Download Mode.
  4. Connect GS3 to computer and wait for Yellow sign on Odin interface.
  5. Add I9300XXDLH4_I9300OXADLH4_I9300XXLH1_BTU.tar.md5 to PDA
  6. Check that the re-partition option is NOT ticked.
  7. Start flash and wait.
  8. Boot into recovery mode and select wipe/factory reset.
  9. Reboot and enjoy Jelly Bean on Galaxy S3.

To make performance smoother and faster while running Galaxy S3 Jelly Bean firmware, an XDA Developer, Jack Barrett, recommends:

  • Disable all animations.
  • Delete widgets from Homescreen.
  • Disable S Voice launch by Homescreen.
  • Freeze or uninstall unnecessary apps.

This update reaches up to 490MB in size so downloading and updating might take a little while depending on your connection.

[easyazon-block align=”center” asin=”B008HTJLF6″ locale=”us”]

[easyazon-cta align=”center” asin=”B008HTJLF6″ height=”42″ key=”amazon-us-tall-orange” locale=”us” width=”120″]

Leave a Reply

Your email address will not be published. Required fields are marked *

Lenovo About To Overtake HP As Number One PC Maker

Fruit Vs. Robot Lets Android and Apple Fans Battle It Out